Interior LED Help

Reply Subscribe

Thread Tools

Search this Thread

Mar 12, 2007 | 04:07 PM

nhra-trans-am

Thread Starter

Moderator

iTrader: (104)

Joined: Aug 2005

Posts: 3,256

Likes: 5

From: Orange County, CA

Interior LED Help

I read keliente's write up on the interior LED modifications. But I am not able to do the headlight swith and TCS switch since those require soldering and resistors. I was wondering if anyone on here would be able to do this for me. I want to get them done with red LEDS.

Anyone?

Mar 12, 2007 | 04:35 PM

ROCNDAV

TECH Junkie

iTrader: (100)

Joined: Mar 2004

Posts: 3,725

Likes: 2

From: Pasadena, CA

Link me. I can do it for you.

Mar 12, 2007 | 05:47 PM

Brian2006

TECH Senior Member

iTrader: (42)

Joined: Dec 2004

Posts: 5,063

Likes: 0

From: Tomball/Nacogdoches TX

I'll do it for you. I just did 6 of them the other day 4 of them were a member off here on tech that needed them done.

Shoot me a PM

Mar 12, 2007 | 06:46 PM

Z95m6

TECH Enthusiast

iTrader: (1)

Joined: Nov 2004

Posts: 531

Likes: 0

From: Newton, ks

I assume you have a TA. If so i have a headlight switch that i soldered in a red led into. It works fine I just swapped from the TA dash to my 97+ Camaro dash. If you're interested I'd do $15 shipped for the switch with the light.

Mar 12, 2007 | 07:04 PM

Red97Z

TECH Enthusiast

iTrader: (22)

Joined: Nov 2005

Posts: 661

Likes: 0

From: Trenton, NJ

I have my 97 headlight switch out of my car, I see where I need to solder, I have two led's, a 5volt one and a 12volt one, both red. Should I just solder one? Perhaps someone could tell me what resistor I need, 470ohm?

Mar 12, 2007 | 08:08 PM

Havok2

11 Second Club

iTrader: (118)

Joined: Jan 2004

Posts: 2,994

Likes: 0

From: RGV texas

thanks brian!

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last