Retro Emblems, how'd you apply them?
Thread Starter
11 Second Club
iTrader: (43)
Joined: Aug 2006
Posts: 5,364
Likes: 2
From: Summerville, SC
Retro Emblems, how'd you apply them? I've got some z/28 emblems coming in the mail and I was wondering how everyone applied them. I was thinking of cutting of the pins and getting some glue and glueing them. What would be the best for that?
TECH Enthusiast
Joined: Oct 2002
Posts: 502
Likes: 0
From: Goleta, CA
Originally Posted by fast01z28
i used my dremel and the cutoff wheel to cut off the pins, then i used the 3M super hold double sided tape. The gray stuff, not the clear stuff.
11 Second Club
iTrader: (27)
Joined: May 2005
Posts: 6,799
Likes: 5
From: Your girl's back door giving her the long stroke while you're at work
Originally Posted by fast01z28
i used my dremel and the cutoff wheel to cut off the pins, then i used the 3M super hold double sided tape. The gray stuff, not the clear stuff.
Originally Posted by 98Camarod
Yeah, but doesn't it show through?
Trending Topics
I used double sided tape like everyone else said. Just make sure you take a razor blade and trip up any parts that might show. I did that on my Z and it looked great, post up some pics when you get it done.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Thread Starter
11 Second Club
iTrader: (43)
Joined: Aug 2006
Posts: 5,364
Likes: 2
From: Summerville, SC
Ok I got the emblems today. I cut the things off, put the tape on and was going for a test fit deal and its curved like a ****. There is a large gap, atleast an 1/8th of an inch. What did you do to over come that?
11 Second Club
iTrader: (27)
Joined: May 2005
Posts: 6,799
Likes: 5
From: Your girl's back door giving her the long stroke while you're at work
I wrapped mine up and stomped the **** out of it. Or you can use a rubber mallet and lay it on a flat surface and massage it until it's right
Originally Posted by Z28/2002
I wrapped mine up and stomped the **** out of it. Or you can use a rubber mallet and lay it on a flat surface and massage it until it's right
that funny
"stomped the **** outta it" LOL