front bumper sagging
Ok i cant find my friggen camera so i tryed to find pics but it wasn't easy. In this pic below of the white T/A i have the piece circled in red. Its right by the hood latch and there will be 2 bolt that connect the bumper to the frame of the car, Simply loosen the bolts then pull up on the bracket and retighten.
oh ok that big *** one that the latch is connected to and the washer fluid is behind.
edit: i loosened the 2 bolts holding it to the frame and it didnt go anywhere when i pulled up.
edit: i loosened the 2 bolts holding it to the frame and it didnt go anywhere when i pulled up.
Last edited by Revelation Z28; Jun 25, 2007 at 05:59 PM.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Originally Posted by nhra-trans-am
you can just loosen the bolts for the hood latch and move the hood latch down, then tighten the bolts back.
