Hey all i have a 6.0 LQ4 that i am trying to install a th350 onto. I bought a LSX/th350 torque converter and was told that my 6.0 flexplate would bolt up no problem. But here's what it looks like.



Should i just modify the hole to make it bolt up?
The pilot looks like it fits great though.



Any advice is appreciated! thanks!

 

I think you do have to elongate the holes if memory serves me correct.

 

Cool thanks for your help. I just enlongated them!

 

I am having this same problem with my ATI converter for my TH350 but my Fuddle converter that was for an LS1 lined up perfect in the 4L60.. what gives? i told ATI when i was ordering it that it was for an LS1 car and it does have 2 sets of bolt holes and both are off one to the inside and one to the outside but the same amount? any suggestions