4th gear only vibration
#1
TECH Apprentice
Thread Starter
Join Date: May 2006
Location: Nebraska
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
4th gear only vibration
I have a bad vibration that occurs in 4th gear (OD) only...it comes on around 62-65 mph at 2000-2500rms... If I shift into 3rd it goes away. If I get on the gas it goes away. I've ruled out the drive-shaft and u-joints, they are all good. Rear end, pinion angle, and wheel bearings look/sound fine. Trans and TC are brand new.
The possible culpits I'm considering are:
-trans and/or motor mounts
-CV joints in the front
....is there anything else I'm missing?
Stroker2112
The possible culpits I'm considering are:
-trans and/or motor mounts
-CV joints in the front
....is there anything else I'm missing?
Stroker2112
#2
TECH Apprentice
Thread Starter
Join Date: May 2006
Location: Nebraska
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
fixed the problem....torque converter lock-up was causing inversion in 4th at low rpm...which was basically a shudder vibrating the entire drivetrain. Once the setting in PCM was adjusted problem went away.