I'm seeing if anyone is running a 4L80e with a 10 bolt. Looking to get a driveshaft length as well as a part number for the conversion ujoint you used. I'm trying to find this out because I can't measure and wait for a shaft to come in.

Any help is appreciated.

Thanks,
Andy

 

I used my stock T56 driveshaft. Online I ordered a 1350 Th400 yoke, and an S3R to 1350 conversion joint.

 

You just made my day! Haha. Nice.

I will ask the tranny builder which style output shaft I am getting so I can order the right slip yoke.

Then I just need the S3R to 1350 conversion joint.

Thanks for the response!

 

I found this guy for $31:
http://www.theujointstore.com/21154.html

 

I did the same with my auto driveshaft. Went to NAPA bought the conversion u-joint and let it rip

 

Good news guys. Thanks.