Flexplate locking tool (4L60e)
04-21-2010, 11:18 PM
#5
11 Second Club
iTrader: (8)
Join Date: Jan 2002
Location: SILSBEE TX
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
may make a tool to hold flywheel
hope the drawing of tool is understandable
use a 1/8 x 2 flat bar about 12 in long insert into flywheel threw the round hole in botton of bellhouseing ,
the notch in side will hold tool in place
PS: THE DRAWING DOES NOT SHOW UP CORRECT ,it should be about 2 in wide all the way down
WITH a small nick in the side to rest in the round hold to hold the tool in place
/\/\/\/\
|...... |
|...... |
|..... <<
| ......|
|...... |
|...... |
hope the drawing of tool is understandable
use a 1/8 x 2 flat bar about 12 in long insert into flywheel threw the round hole in botton of bellhouseing ,
the notch in side will hold tool in place
PS: THE DRAWING DOES NOT SHOW UP CORRECT ,it should be about 2 in wide all the way down
WITH a small nick in the side to rest in the round hold to hold the tool in place
/\/\/\/\
|...... |
|...... |
|..... <<
| ......|
|...... |
|...... |
