So is this a normal thing to break?
So is this a normal thing to break? broke my torque arm mount on a low 1.6 60' launch... on a side note i did trim one of the ears down because at 3:00am trying to get this thing back together couldnt get the rubber over the torque arm and twist both ears into the bottom slot. I got pissed and got out the cut off wheel.. I KNOW.. lol...
I know thats why it pulled out. However the bottom bracket bent up which allowed it to slip out... so is bending the bottom bracket a common thing? Obviously if the outer piece had slipped out it wouldnt have bent the bottom piece as there wouldnt have been any stress on it.
I know thats why it pulled out. However the bottom bracket bent up which allowed it to slip out... so is bending the bottom bracket a common thing? Obviously if the outer piece had slipped out it wouldnt have bent the bottom piece as there wouldnt have been any stress on it.
