How do you remove the 4L60E dipsick tube?
TECH Fanatic
Joined: Jun 2002
Posts: 1,227
Likes: 0
From: Indianapolis
Mine would not come out untill i dropped the tranny, then it had too. I had a hard time with it. The problem is it hits under the firewall before it pulls out. I put a long extension under it and hit it with a hammer and it came out.If your car is on jackstands, stand on a milk crate or something while your doing it.
Thread Starter
On The Tree
Joined: Jun 2002
Posts: 150
Likes: 0
From: DFW
The tranny is out of the car. I had it on stands, but I don't now. I just didn't want to pull to hard for fear that I would damage something else, like the rear coil pack or something. I'll try hammering from the bottom. I'm putting a TH400 in, and I plan on getting a Madman dipstick & tube. Will it be just as hard to put in as this one has been to get out?
Originally Posted by Woody
The tranny is out of the car. I had it on stands, but I don't now. I just didn't want to pull to hard for fear that I would damage something else, like the rear coil pack or something. I'll try hammering from the bottom. I'm putting a TH400 in, and I plan on getting a Madman dipstick & tube. Will it be just as hard to put in as this one has been to get out?
Look at the link below in section "h" for a picture.
http://www.modernmusclecars.net/articles/TCinstall/
John
Thread Starter
On The Tree
Joined: Jun 2002
Posts: 150
Likes: 0
From: DFW
Originally Posted by JNorris
There is a 15mm bolt that holds it to the back of the head.
Look at the link below in section "h" for a picture.
http://www.modernmusclecars.net/articles/TCinstall/
John
Look at the link below in section "h" for a picture.
http://www.modernmusclecars.net/articles/TCinstall/
John
