TH350 swap driveshaft ?
#1
TECH Resident
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: SoCal, SFV
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
TH350 swap driveshaft ?
Doing a TH350 swap into my LS1/4L60E swapped 96Z28. Tried searching for the measurements for driveshaft that will fit a TH350 short tailshaft to a stock 10 bolt.
I know Spohn makes a ready to drop in driveshaft but I've heard of fitment issues. Been looking into Denny's 3" 1330 series or PST 3" 4130 series but need correct measurements and I don't have time to do the swap, measure and wait to have the driveshaft made since I'll be borrowing a friends backyard for the swap.
Any help is greatly appreciated.
Also any suggestions on my swap? I have a TH350 6" tailshaft I believe, Hughes Flexplate and spacer, modified BMR crossmember, Lokar 36" Dipstick. I believe the trans already has the VSS and gear installed since the trans came out of a LS1 F-Body. How would I check?
I know Spohn makes a ready to drop in driveshaft but I've heard of fitment issues. Been looking into Denny's 3" 1330 series or PST 3" 4130 series but need correct measurements and I don't have time to do the swap, measure and wait to have the driveshaft made since I'll be borrowing a friends backyard for the swap.
Any help is greatly appreciated.
Also any suggestions on my swap? I have a TH350 6" tailshaft I believe, Hughes Flexplate and spacer, modified BMR crossmember, Lokar 36" Dipstick. I believe the trans already has the VSS and gear installed since the trans came out of a LS1 F-Body. How would I check?
#4
11 Second Club
iTrader: (27)
Join Date: May 2005
Location: Your girl's back door giving her the long stroke while you're at work
Posts: 6,801
Likes: 0
Received 3 Likes
on
3 Posts
You can use a stock length driveshaft on a long tail TH350( 9" ), but it is still a little short
If you have a short tail ( 6" ), add atleast 3" to your stock driveshaft
If you have a short tail ( 6" ), add atleast 3" to your stock driveshaft