Need help starter is hitting flexplate th400
#1
Need help starter is hitting flexplate th400
Guys need help bad pulled the motor out of the car 2 months ago due to spun rod bearing when I did found out I needed a new block so I bought a 2000 model ls1 block mine was 98 so I built it put it back in now the starter seems like it hits the flex plate when engaged Amy suggestions because before rebuild the car ran fine with the same setup it has bmr flexplate for ls1 to th 400 and a monster converter anything please help!!!!!
#4
12 Second Club
iTrader: (51)
Join Date: May 2010
Location: MI
Posts: 1,008
Likes: 0
Received 0 Likes
on
0 Posts
Never heard that before. I just did my flexplate and 4l60e and it states right on the instructions to make sure it is within .010-.020 - measured mine and it was .020 so didn't need to shim.