Th400 swap! Help!!
Th400 swap! Help!! I was wondering if anyone knows a good reputable place to have a driveshaft made for my 1998 firebird. I have done a th400 tranny with a qp 9 inch using a factory ford third member for now. I am looking for a little insight as to what driveshaft length I need as well. Any help is greatly appreciated and I hope I am posting in the right forum. Thanks
I like Carolina Driveline, but there are tons of good driveshaft builders out there. Just call whoever you decide to use up and they will tell you what measurements they need you to provide to them. I used to know the required length off the top of my head, but I can't think of it right now lol
Ok thanks. I'll try to find some contact information for them.
The only thing is I haven't finished the car yet but have a few weeks off before long and wanted to try to put it together and get it tuned then.
The only thing is I haven't finished the car yet but have a few weeks off before long and wanted to try to put it together and get it tuned then.
