i need a video or picture step by step on how to pull a th350 off a sbc 350
i removed the 9/16 bolts (like 6 i think) but no luck. i assume i need a pry bar?

any help or walkthroughs would be very appreciated

 

Removing the 3 Torque Converter Bolts will help.

 

where are those

 

The converter is attached to the Flywheel with 3 bolts, take them out and push the converter back into the trans
MAKE sure all bolts are out of the trans to engine, grab the tailshaft, and wiggle it very slowly-there are two locating pins bet the last 2 bolts on each side, they can get a little rusty, make it hard to get off