Driveshaft?
Driveshaft? Got the Th400 installed and need to measure for a driveshaft. I have a moser 9in I put the yoke all the way in the transmission and measured from the flat part of the yoke to the flat part on the 9in. I got 45in. Does the sound about right. Also how much play should I want 1in? So get a 44in drive shaft made?
Thanks
Thanks
TECH Enthusiast
Joined: Sep 2016
Posts: 518
Likes: 0
From: North Jersey
When I measured for the 4l80e , I bottomed the yoke out then pulled it out 3/4", then measured.
I would think an inch is OK.
Was the rear sitting at ride height?
Make sure you tell the DS guy how and where from you measured it.
I would think an inch is OK.
Was the rear sitting at ride height?
Make sure you tell the DS guy how and where from you measured it.
Moderator
Joined: Aug 2010
Posts: 7,323
Likes: 529
From: Ann Arbor, MI
I have ordered custom driveshafts from different vendors. With the differential tubes on jack stands to keep the ride height correct, I crawl under the car with a tape measure and a cell phone and then call the DS vendor and ask exactly how they want it measured.
