I need a clear photo of a 4L80E TransGo HD2 separator plate. I purchased several kits with the plates not riveted and no instructions. I have the instructions taken care of, however I need to put the plates together. Why these were not together, I do not know. Thanks in advance.

 

that 3 layer plate is garbage.
hot stinky garbage
The plate with the long slot to tie together the direct and reverse circuit will go in the middle
the plate that blocks the circuit I *believe* goes VB side

don't take that as gospel, lets wait for some photos.
Mainly commenting so I can easily follow along with this short saga

 

Dana, I would not use that separator-plate...

Perform your Dual-Feed the "normal" way.

 

I need this for customers that have bought the TransGo HD2 from me. I know how the plates line up. I need to put in the rivets here. That is why I am asking for a photo of the HD2 separator plate. I thought I was making myself clear on this. I gather I did not.

 

Sorry, I do not have any of those Separator-Plates.

I have not purchased a TransGo kit for the 4L80E before.

 

Can't remember the last time I used an HD2
anytime one comes through the shop, the plate gets frizbee'd out to the scrap pile as soon as the VB comes off

Would help if I could dana.
Apologies