View Poll Results: Did this question help others in need?
Yes
0
0%
No
1
100.00%
Somewhat yes
0
0%
Voters: 1. You may not vote on this poll
4l80e swap on Silverado
Thread Starter
Teching In
Joined: Jul 2023
Posts: 30
Likes: 3
From: California
4l80e swap on Silverado I have 4l80e for my 06 5.3 Silverado ext cab, I have everything for it other than a driveshaft I believe the trans is 32 inches long and I have a wheel base of 119 inches I'm not entirely sure and my bed is 78in. what size drive shaft do I need because my stock one won't work because I had a transfer case.
lol.... so basically I'm looking for a driveshaft size and a short or long slip yoke to go with it for the 4l80e.
Ive also heard of people putting a 2500 shaft on it but the u joints was a problem.
Please support me with information Thank you guys....
lol.... so basically I'm looking for a driveshaft size and a short or long slip yoke to go with it for the 4l80e.
Ive also heard of people putting a 2500 shaft on it but the u joints was a problem.
Please support me with information Thank you guys....
TECH Junkie
Joined: Dec 2012
Posts: 3,614
Likes: 1,326
From: Iowa
Do you own a tape measure?
That is the only correct way to know what you will need.
Lifting or lowering a truck can slightly alter the driveshaft length needs.
Some trans have full splined outputs, some don't...that will change yoke engagement
Etc
Just measure and have a shaft built to suit your swap
That is the only correct way to know what you will need.
Lifting or lowering a truck can slightly alter the driveshaft length needs.
Some trans have full splined outputs, some don't...that will change yoke engagement
Etc
Just measure and have a shaft built to suit your swap
