4L60E 3-4 clutch pack
05-04-2005, 10:33 PM
#1
Teching In
Thread Starter
Join Date: May 2005
Location: Austin,Texas
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
4L60E 3-4 clutch pack Hey fella's and ladies...perhaps,
I'm new to this so please bear with me. My question is in regards to a 4L60E rebuild I'm attempting. I got everything pulled apart, cleaned, labeled ect.. and I'm in the process of installing the 3-4 clutch pack in the input housing and low and behold it appears that I'm missing a part (3-4 "stepped" apply plate)...or am I. The manual I'm using (ATSG) is calling for this apply plate to be installed after the 3-4 clutch retainer ring. I don't recall seeing this "stepped" apply plate during disassembly or perhaps I wasn't as good at keeping my ___ together as I thought I was. Can anyone out there tell me if there was some sort of mod to this transmission where the plate was removed or is now a combination retainer/apply plate? The thing seems to have vanished into thin air. If in fact I did lose the damm thing, can someone tell me where i can order one?
Any help will be greatly appreciated.
I'm new to this so please bear with me. My question is in regards to a 4L60E rebuild I'm attempting. I got everything pulled apart, cleaned, labeled ect.. and I'm in the process of installing the 3-4 clutch pack in the input housing and low and behold it appears that I'm missing a part (3-4 "stepped" apply plate)...or am I. The manual I'm using (ATSG) is calling for this apply plate to be installed after the 3-4 clutch retainer ring. I don't recall seeing this "stepped" apply plate during disassembly or perhaps I wasn't as good at keeping my ___ together as I thought I was. Can anyone out there tell me if there was some sort of mod to this transmission where the plate was removed or is now a combination retainer/apply plate? The thing seems to have vanished into thin air. If in fact I did lose the damm thing, can someone tell me where i can order one?
Any help will be greatly appreciated.
05-04-2005, 11:40 PM
#2
TECH Enthusiast
iTrader: (4)
Join Date: Aug 2003
Location: Phoenix AZ
Posts: 633
Likes: 0
Received 0 Likes
on
0 Posts
the stepped apply plate(653) is pretty thick.
try putting all the parts in
see if there is space left over between the retaining ring(656) and the 3-4 backing plate(655)
try putting all the parts in
see if there is space left over between the retaining ring(656) and the 3-4 backing plate(655)
