I was wondering what kinda of welding you need to use for them? So far everyone I talked to about installing them said I need to arc weld them. I read someone on this board said to do MIG. I'm not into welding that much so is there a differance and what one should I go for. Thanks

 

MIG welding is just fine. Same welder setup that is used to install exhaust parts. I don't know of anyone that Heliarc welds subframes on, that is kind of overkill.

Tony

 

Just what I was looking for. I wanted to know about weaking the metal and which way was the best. I have also seen some have not taken out their carpet?

I'm ordering BMR's today, and I need to make decisions. <img src="gr_tounge.gif" border="0">