Automatic Transmission 2-Speed thru 10-Speed GM Autos | Converters | Shift Kits
Sponsored by:
Sponsored by:

knocking noise-tranny mount?

Thread Tools
 
Search this Thread
 
Old 01-07-2007, 10:12 PM
  #1  
TECH Addict
Thread Starter
iTrader: (27)
 
SVT THIS's Avatar
 
Join Date: May 2005
Location: Owasso, Ok
Posts: 2,238
Likes: 0
Received 1 Like on 1 Post

Default knocking noise-tranny mount?

After my header and stall install I noticed an obvious knocking or clunking noise every now and then. It is usually when I get on it really hard or if I accelerate into turns. I got under the car to see if the headers could be bumping into something (that is what it sounded like) and one of the mounts looked like it could be going. Does this sound right? How much is a typical tranny mount replacement run?
Old 01-09-2007, 12:54 PM
  #2  
TECH Addict
Thread Starter
iTrader: (27)
 
SVT THIS's Avatar
 
Join Date: May 2005
Location: Owasso, Ok
Posts: 2,238
Likes: 0
Received 1 Like on 1 Post

Default

To the Top
Old 01-09-2007, 01:53 PM
  #3  
TECH Enthusiast
 
GXPPOWER's Avatar
 
Join Date: Aug 2005
Location: crossett, Arkansas
Posts: 701
Likes: 0
Received 0 Likes on 0 Posts
Default

im not sure but i also have a bad tranny mount. i dont think their expensive at all. and sounds liek you got same probs as me.

though my car if im at a low idle spot in 2nd gear and tap the gas i can hear a clunk sound.
Old 01-09-2007, 10:51 PM
  #4  
11 Second Club
iTrader: (43)
 
98Camarod's Avatar
 
Join Date: Aug 2006
Location: Summerville, SC
Posts: 5,364
Likes: 0
Received 2 Likes on 2 Posts

Default

The y pipe is probably hitting the driver side floor board or the support brace. It could also be the trans mount or engine mounts.




All times are GMT -5. The time now is 08:18 PM.