99DWPTA

iTrader: (10)

i got (8) bolts off the bell housing
i got all 3 bolts off torqe converter
i got the cooling lines out
idp stick tube out
all wiring unpluged
ive tried everything to get it to come off
i sparayed PB blaster on the dowel pins and let it sit for a day
ive tried prying the trans off
it will not budge it just moves motor up and down when prying and wiggling it.
this was soupose to be a 2 day project and its taken me 20hrs and 4 days to get this far.
and suggestions please help
i even hooked a come along to rear end and to trans
trans didnt budge

billybadd

iTrader: (21)

you gotta get the motor and trans at the right angle and shake the hell out of it, It will come off. Took me about an hour the first time. try jacking up on the tail shaft slowly but be careful. Take your time.

99DWPTA

iTrader: (10)

i got it off! thanks

theblur98ss

iTrader: (71)

Another trick is to pull the starter and put a 2x2 up against the tranny and beat it with a sledge hammer.

WE TODD DID

iTrader: (2)

Bolt a chain to the extension housing where the torque arm mounts, and attach the other end of the chain to a vehicle behind your car. Drink a few, and then let it rip. Works every time.

performabuilt

iTrader: (25)

lol