FLP Level IV good for monster H/C?
Thread Starter
Launching!
Joined: Jan 2002
Posts: 262
Likes: 0
From: here and there
FLP Level IV good for monster H/C? I was going to do GTP Stage II's milled to 11:1 CR, TR230, LS6 intake, ASP Pulley, Ported Oil Pump, TP4400, Moser 12 bolt w/3.73's and lost a couple hundred lbs.
Will the FLP hold up to launches on 28" ET Drags and take around a 100 shot of N20 off the line, will it be just good in general, also what gear do you reommend, I was going with a 3.73
What will this combo run assuming it can cut 1.45-1.50 or lower 60'?
Will the FLP hold up to launches on 28" ET Drags and take around a 100 shot of N20 off the line, will it be just good in general, also what gear do you reommend, I was going with a 3.73
What will this combo run assuming it can cut 1.45-1.50 or lower 60'?
12 Second Truck Club
Joined: Feb 2002
Posts: 5,574
Likes: 0
From: Sacramento, CA
Re: FLP Level IV good for monster H/C? Mine is holding up great!
Althought I am not quite at the HP level I am supposed to be yet but I have not heard one pip out of this thing yet. I think it will hold up just fine.
I am changing over to a wet-kit here shortly so we'll find out. <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Althought I am not quite at the HP level I am supposed to be yet but I have not heard one pip out of this thing yet. I think it will hold up just fine.
I am changing over to a wet-kit here shortly so we'll find out. <img border="0" title="" alt="[Smile]" src="gr_stretch.gif" />
Re: FLP Level IV good for monster H/C? I have an FLP level IV, and I am cutting 1.4's on 28" Hoosiers.
As with any A4 transmissions, cool down the transmission and avoid hotlapping. I will not race if the temps are over 225F.
As with any A4 transmissions, cool down the transmission and avoid hotlapping. I will not race if the temps are over 225F.