Automatic Transmission 2-Speed thru 10-Speed GM Autos | Converters | Shift Kits
Sponsored by:
Sponsored by:

Not sure what's wrong

Thread Tools
 
Search this Thread
 
Old Aug 23, 2008 | 02:57 AM
  #1  
RealArmyMan's Avatar
Thread Starter
On The Tree
iTrader: (2)
 
Joined: Mar 2006
Posts: 112
Likes: 0
Default Not sure what's wrong

I think my TC is fuxored up. I was getting on the highway, normal driving, between 1/4 and 1/2 throttle, the tranny downshifted twice, bounced off the rev limiter, I immediately let off the gas. It upshifted but wouldn't go into overdrive. Then when I went to get off the highway and turn at the light, it didn't take anything to get going. Totally didn't feel like it had a big stall in it. I am so pissed right now. Any ideas what might be wrong?
Reply
Old Aug 23, 2008 | 09:14 AM
  #2  
FLT's Avatar
FLT
FormerVendor
iTrader: (1)
 
Joined: Sep 2005
Posts: 6,620
Likes: 4
From: Wood Dale, Illinois
Default

How is the condition of the oil and the level of it? Also are you getting any codes? Usually when a converter goes away the stall will increase not tighten up.
Reply
Old Aug 23, 2008 | 12:33 PM
  #3  
RealArmyMan's Avatar
Thread Starter
On The Tree
iTrader: (2)
 
Joined: Mar 2006
Posts: 112
Likes: 0
Default

Haven't checked anything out yet. It happened about 1am and I was too pissed to pull it in the garage and start checking things out. Didn't throw any codes. I'll scan it to see if there's anything pending
Reply
Old Aug 23, 2008 | 01:30 PM
  #4  
RealArmyMan's Avatar
Thread Starter
On The Tree
iTrader: (2)
 
Joined: Mar 2006
Posts: 112
Likes: 0
Default

Ya, it's gone. Checked the fluid, level was fine, wasn't burnt. Went to pull it in the garage. Wouldn't go into gear. I'd have the selector in reverse or drive and nothing. Just sat there and revved. No codes. ****. Oh well, atleast I have another car. And this just gives me the need to upgrade now
Reply




All times are GMT -5. The time now is 09:47 AM.