Small update
Thread Starter
On The Tree
Joined: Mar 2011
Posts: 193
Likes: 0
From: Pittsburg, Kansas
Small update Well a few weeks back I broke the 1.76 gear set in my glide and finally got it back together with a 1.69 straight cut bte set and so far everything is working good.
Went to the track Friday to make some hits, didn't get much of a good run in. Had it on a safe tune for the first pass but I could tell the new gear set calmed it down a bunch on the launch, my 60 was a little off, 1.38 but it was coming on harder than it did before 100-200ft out. The track wasn't there and I had to get out early.
So I came back to the pits and all the plugs looked good so I was going to put 2 deg back in and make another pass but my fuel reg on the nitrous side wouldn't hold and we couldn't get it fixed and didn't have a spare, so we called it a night.
Going to get it fixed this week and I have no doubt it will go .60s on the 250.
I am also picking up some 29.5s to throw on it and hopefully run it to the 8s out the back door. I think it's about time for some laundry on the back!
Went to the track Friday to make some hits, didn't get much of a good run in. Had it on a safe tune for the first pass but I could tell the new gear set calmed it down a bunch on the launch, my 60 was a little off, 1.38 but it was coming on harder than it did before 100-200ft out. The track wasn't there and I had to get out early.
So I came back to the pits and all the plugs looked good so I was going to put 2 deg back in and make another pass but my fuel reg on the nitrous side wouldn't hold and we couldn't get it fixed and didn't have a spare, so we called it a night.
Going to get it fixed this week and I have no doubt it will go .60s on the 250.
I am also picking up some 29.5s to throw on it and hopefully run it to the 8s out the back door. I think it's about time for some laundry on the back!
