Msd 6014
Thread Starter
Teching In
Joined: Aug 2020
Posts: 7
Likes: 0
Msd 6014 Hello all gear heads, I am fairly new to this and I am looking for your expert info and help. I have a gen 3 6.0L, LS3 heads, headers, Texas Speed cam (222/230.600/.615), quick Fuel 750 carb. I am looking to fine tune a bit. What is a good base starting point when creating a custom setting for the MSD? Thanks in advance!
10 Second Club
Joined: Aug 2010
Posts: 4,465
Likes: 192
From: Harford Co. Maryland
As above with the 6010 (link below) is pretty much the same except for the 24 Vs. 58 tooth wheel is reads from.
Lots of good reading there.
https://ls1tech.com/forums/carburete...iming-set.html
Lots of good reading there.
https://ls1tech.com/forums/carburete...iming-set.html
TECH Fanatic
Joined: Mar 2014
Posts: 1,266
Likes: 165
Start your ramp at 1400rpm go up in a angle to be all in by 550. I would play it safe and start at 26 degrees of timing. Get rid of all the dots You only need 2 dots. Then tune for mph at the track. Makes it a lot easier. We landed on 28 but every combo can be different.
10 Second Club
Joined: Aug 2010
Posts: 4,465
Likes: 192
From: Harford Co. Maryland
