Conversation Between joelster and Hit em Up
Showing Visitor Messages 1 to 3 of 3
- 04-22-2012 03:36 PMI run Jesel #http://www.jegs.com/i/Jesel/549/KSS-416060/10002/-1 , my pushrods were custom ordered from Trendpushrods.com . They are 3/8ths that taper to 5/16's on the ends, .080" wall chromoly in 7.800" length. They were around $165ish. Awesome company to deal with. You may need longer ones depending on what lifter you run, whether or not your block has been decked, head gasket thickness, etc.
- 04-22-2012 03:17 PMHey I'd like to no what part number jesel shaft mounts you're running for the afr227? I've been looking at the jesel and t&d haven't made a decision yet.Also what brand 3/8 pushrods are you running? Thanx for the help I'm at the finishing touches of my new combo and wanted some more input other than just my builder.
- 09-10-2011 01:10 PMHey question for you about the xfi 292 and springs.I'm running a set of nitrated 918s and am having valve float very bad at 6500rpm...6400rpm is perfect but if I push past that it sounds like I'm hitting a rev limiter.AI set up the heads and springs Intake is 1.720,ex1.750 on one head and 1.780,1.813 on other? Do you think I can just reshim these springs or should I just upgrade all together? Thx in advance for any help or suggestions...Steve