1985 Monte Carlo 6.0 LQ4 swap
10-18-2010, 03:12 PM
#22
Teching In
Thread Starter
iTrader: (1)
Join Date: Aug 2010
Location: Columbus, IN
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
SHEEEESH......that is terrible!!! WHOA, good thing you are ok...That really stinks man.
qelsupreze
Not sure if the truck intake would fit under a stock hood, I test fit it on the engine without the hood on and it sat too tall for my liking, but it may fit.
Also, Adding a picture of the engine as it is right now.
qelsupreze
Not sure if the truck intake would fit under a stock hood, I test fit it on the engine without the hood on and it sat too tall for my liking, but it may fit.
Also, Adding a picture of the engine as it is right now.
12-14-2017, 07:41 PM
#24
Registered User
Join Date: Dec 2017
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Monte Carlo ls1 I have a 1985 Monte Carlo SS now the issue I’m having is which wires in my factory harness am I going to use. I️ took my Harness from the passenger side tape up tucked in passenger fender I’m assuming the Harness coming out of driver side I will be Reusing. Wanted to know which wires in this harness is for temp gauge oil pressure gauge RPM gauge voltage gauge. Any help will be greatly appreciated.
