To cut or not to cut? (My Harness)
#1
TECH Fanatic
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: florida
Posts: 1,415
Likes: 0
Received 0 Likes
on
0 Posts
To cut or not to cut? (My Harness)
I would like to know if I can get away from cutting wire's. I would like to just fold them back and forth in the harness itself. My second question is if I do fold them will they cause any interference being that they go pass each other? Dont want to cut in case I want to move again for some reason.
Thanks Jaime
Thanks Jaime
#2
Staging Lane
Join Date: Dec 2005
Location: Portland, Oregon
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
start by not cutting anything until you're sure you have everything hooked up properly, tucking and bundling wont cause any issues unless you're like intwining them around the spark plug wires or something, it's a non-issue.
once you're confident you have everything wired in you need then go in and clean up the harness for a nice finished look.
once you're confident you have everything wired in you need then go in and clean up the harness for a nice finished look.
#4
TECH Fanatic
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: florida
Posts: 1,415
Likes: 0
Received 0 Likes
on
0 Posts
start by not cutting anything until you're sure you have everything hooked up properly, tucking and bundling wont cause any issues unless you're like intwining them around the spark plug wires or something, it's a non-issue.
once you're confident you have everything wired in you need then go in and clean up the harness for a nice finished look.
once you're confident you have everything wired in you need then go in and clean up the harness for a nice finished look.
Which wires are you talking about causing interference with stereo? Cant think of any wires for stereo running threw the harness.