harness blues...
harness blues... After reading all the great posts and stickies, I felt confident enough to tackle the harness....I'm still (a little) confident that I can do it, but I have a couple of questions to my 2006 5.3 (L59) truck harness.
1. Which two pinouts are used for the OBDII serial data signals? For the two ground wires...can I cross the ground on the plug, or does it have to be both ground wires coming to the plug?
2. Which pin #'s can I eliminate on plug C2, PCM (c1,c2), c152? I know what I must keep, just not sure what I can ditch. I'll be running pcm controlled a/c, evap stays, pcm controlled fans, and fuel level sensor (c152 pin K for ethanol purpose)?
3. I love the 1998 LS1 retrofit schematic. I'm using it as a reference, but it would be great if there's one specific to the truck harness. Is there?....I'd pay!
1. Which two pinouts are used for the OBDII serial data signals? For the two ground wires...can I cross the ground on the plug, or does it have to be both ground wires coming to the plug?
2. Which pin #'s can I eliminate on plug C2, PCM (c1,c2), c152? I know what I must keep, just not sure what I can ditch. I'll be running pcm controlled a/c, evap stays, pcm controlled fans, and fuel level sensor (c152 pin K for ethanol purpose)?
3. I love the 1998 LS1 retrofit schematic. I'm using it as a reference, but it would be great if there's one specific to the truck harness. Is there?....I'd pay!
