What can I get rid of?
Thread Starter
Teching In
Joined: Nov 2008
Posts: 7
Likes: 0
From: Iowa
What can I get rid of? I'm transplanting an LS1/t56 into my Westfield (Lotus 7 Clone) autocross car. I need some advice on what all I can get rid of in the wiring harness. This is not a street car, autcross only with 35 to 60 second runs. I want it to be as simple as possible.
Jeff Christianson
Jeff Christianson
more to removing circuits than cutting plugs, remove the pins at the PCM connector..if your not using the LS1 alternator that circuit could be deleted also, as well as AIR system circuits
I found it best to just lay it out on the engine, connect all of the equipment that you want and/or removed what you don't want. Unwrap the harness and just remove anything that is no longer connected or needed. This will also allow you to route the harness where you want it to be.
It is easy to remove the connector and wire all the way to the PCM connector (Red/Blue), just open it up and pust the wire/pin out.
The usual stuff:
Both Rear O2's
EGR (if you have it)
AIR system
A/C (clutch and pressure sensor)
EVAP (Valve/Solenoid)
If you go SD tune, then the MAF
It is easy to remove the connector and wire all the way to the PCM connector (Red/Blue), just open it up and pust the wire/pin out.
The usual stuff:
Both Rear O2's
EGR (if you have it)
AIR system
A/C (clutch and pressure sensor)
EVAP (Valve/Solenoid)
If you go SD tune, then the MAF
