PCM connectors

Reply Subscribe

Thread Tools

Search this Thread

Dec 22, 2009 | 10:26 PM

the450r

Thread Starter

TECH Regular

iTrader: (1)

Joined: May 2008

Posts: 417

Likes: 6

From: Lincoln, NE

PCM connectors

Im doing my own wiring and i was wanting to eliminate the wires for the down stream O2, Evap, ect. The control and signal wires that run to the PCM connectors. Are the rubber oem plugs for the terminals available. Or do you leave the wire(s) in there and cut them short and tape them off?
thanks

Dec 22, 2009 | 11:03 PM

G-Body

sawzall wielding director

iTrader: (4)

Joined: Sep 2004

Posts: 3,148

Likes: 12

From: Downers Grove, IL

You could leave the wires in and tape them off. But most people tend to fully remove them and then put silicone in the empty holes.

Dec 23, 2009 | 05:34 AM

poconojoe

Banned

iTrader: (43)

Joined: Aug 2008

Posts: 1,066

Likes: 3

From: Northeast PA

You can only reseal the membrane on the top of connector, since unlike other connectors, that will be missing the terminals on both sides on the connectors, the PCM will always have a terminal, so you can't plug the hole in the harness side, since you will no longer be able able to put the plug in.

Reply Subscribe