Water Pump Pressed in Outlet Fitting
Thread Starter
Teching In
Joined: Jan 2010
Posts: 20
Likes: 1
Water Pump Pressed in Outlet Fitting So I was trying to tweak the angle on the waterpump outlet pipe and it popped out the press fit between the steal pipe and water pump. It looks like it was epoxied in from the factory. It is a press fit but not a very tight fit.
Has any one had any luck resecuring the outlet pipe after it was removed? I was thinking use some JB weld and knock it back in.
Has any one had any luck resecuring the outlet pipe after it was removed? I was thinking use some JB weld and knock it back in.
Loctite has a product for that.. Here's the number that I have:680.
A pdf tech sheet...
http://www.fiberoptics4sale.com/pdf/...spec-sheet.pdf
A pdf tech sheet...
http://www.fiberoptics4sale.com/pdf/...spec-sheet.pdf
Just so happens those holes are the perfect size for an NPT tap. Tap it, use a NPT/barb fitting. You can probably find one that's the correct angle.
I had to mod mine to fet over the suspension.
I had to mod mine to fet over the suspension.
