ls1 steam line?
Thread Starter
TECH Apprentice
iTrader: (9)
Joined: Mar 2010
Posts: 326
Likes: 0
From: georgetown ky
ls1 steam line? i have heard i need a steam line in the top of the water pump. but when i do that were does the other end of the hose go too?
am runing a fast 92mm intake with a nick will. 92mm tb.
am runing a fast 92mm intake with a nick will. 92mm tb.
Thread Starter
TECH Apprentice
iTrader: (9)
Joined: Mar 2010
Posts: 326
Likes: 0
From: georgetown ky
i have the cross over pipe for the front an it has a hose on it now for the dealer. so i though it went somewere eles.
so i just need to drill the water pump an get a longer hose's for it to reach the cross over pipe then.. Trending Topics
u dont have to modify the water pump i just cut out a section of upper radiator hose right in front of the radiator took a pipe that fit inside iit real well about 4 inchs long then drilled and welded a smaller pipe perpendicular to the bigger pipe right in the center of the 4 inch pipe. then just ran a rubber hose for the steamline from the crossover tube to the upper radiator hose. its much easier and doesnt risk messin ur pump up from metal shards
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo Thread Starter
TECH Apprentice
iTrader: (9)
Joined: Mar 2010
Posts: 326
Likes: 0
From: georgetown ky
u dont have to modify the water pump i just cut out a section of upper radiator hose right in front of the radiator took a pipe that fit inside iit real well about 4 inchs long then drilled and welded a smaller pipe perpendicular to the bigger pipe right in the center of the 4 inch pipe. then just ran a rubber hose for the steamline from the crossover tube to the upper radiator hose. its much easier and doesnt risk messin ur pump up from metal shards
Teching In
Joined: Sep 2007
Posts: 34
Likes: 1
Here's a part that will work, or you can make your own.
http://www.jagsthatrun.com/Pages/Par...g_LSI-tee.html
http://www.jagsthatrun.com/Pages/Par...g_LSI-tee.html
