Wire harness basic ?
#1
Wire harness basic ?
I have been reading here for a while. I am putting a LS1 in a 81 Trans Am. As far as my wire harness what am I missing I need to delete Vats or do a resistor mod to it delete AC and EGR? Is there any other things I am missing to just get the motor to start and run? I will be runnig a TH400 the LS1 had a T56 behind it. Thanks for any help.
#2
I have been trying to research this also, here is a link to a good site i had came across
http://www.thirdgen.org/techboard/lt...rt-finish.html
http://www.thirdgen.org/techboard/lt...rt-finish.html
#5
TECH Resident
iTrader: (26)
Join Date: Feb 2006
Location: myrtle beach, sc
Posts: 781
Likes: 0
Received 0 Likes
on
0 Posts
Check out the FAQ in this section. There's a good bit of info on making your harness a true "stand-alone" harness. I'm going to go this route when swapping a 6L into my 74 corvette.
#8
Yea basicly I want to get the motor in and get it started before I do any mods. I will go in bone stock first. I have pleanty of resistors laying around and I did that mod on my other car for a remote start was not too hard. I was thinking of getting HP tuners one day so I can tune both cars.