rennat_2006

iTrader: (10)

Dont know if this is the right forum for this or not so i appologize mods if you have to move.

Wondering if there is any members on here that are doing LS swap harness mods, Im wanting the un-needed wiring taken out of my harness(emissions stuff, trans stuff, and there is a O2 sensor connector i believe it is that was cutoff from whoever pulled the harness(i bought harness already pulled).

We are putting a 5.3l in my little brothers 79 chevy k10 and depinned the harness ourself and removed the wires but ended up with just a big tangled up rats nest of wiring from moving the harness around tracing wires through and such. Ended up being a nightmare and it was so tangled we depinned every pin from the pcm connectors and seperated each wire out to its individaul connector and had to lay it on his engine and put the harness back together from there.

It is a 99-02 truck harness(red/blue connectors).

97badass

iTrader: (8)

try the_merv he MIGHT be able to help you guys out

lamdenali

iTrader: (5)

I think Pocket is still doing it ?

STEEPSS

iTrader: (30)

aknovaman

He does great work.

psiconversion

iTrader: (5)

If you dont find someone to rework we have them new for $499, free shipping to LS1TECH.COM members. Brand new with extended length to mount the PCM under the dash.

Jon
PSI

fat tony157

iTrader: (12)

I used this guy I found on ebay. I was a little hesitant, but you can't beat his price. He did some very nice work. It looked nice and it works perfectly. Cost me $249 + the cost of shipping it to him. I opted to not have the DLC port added in, this is another $15 or so. Turn around time is around 3 weeks. I put a link to his listing below.

Removed nonsponsor link

the_merv

iTrader: (88)

I've wired a few things...

That's a good price with the EBAY one there..