using LS1 harness on 5.3 questions
using LS1 harness on 5.3 questions I have a friend who right now is running a 1999 ls1 engine harness and PCM flashed to a 2003 5.3L program. He has LS injectors to match the harness but that is all he had done to work with the harness. The oxygen sensors had to be tuned out (run on open loop) because with them in use the engine would buck and not run right at all. Anyone know how to make it work w/ the oxygen sensors?
Is your friend running the 5.3 MAF sensor or the LS1 MAF sensor? Is the tune setup for the MAF sensor that he is running. The reason that it probably runs better without the O2s hooked up is because it is running in open loop and not using the MAF tables. I assume you are running the LS1 Intake as well?
Jon
PSI
Jon
PSI
__________________
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
Your Source for LSX Conversion Parts!
www.psiconversion.com
Ebay Store
Facebook/psiconversion
Instagram/psiconversion
'Dont Let EFI Pass You By!'
Is your friend running the 5.3 MAF sensor or the LS1 MAF sensor? Is the tune setup for the MAF sensor that he is running. The reason that it probably runs better without the O2s hooked up is because it is running in open loop and not using the MAF tables. I assume you are running the LS1 Intake as well?
Jon
PSI
Jon
PSI
The intake is the 5.3L intake also (he swapped out for LS1 injectors to match the wiring harness, which is also off a 1998 LS1)
I'm getting tuning software myself, and will be able to see what is going on. What should I look for?
hey guys I got some data logging done. I used the default imperial.cfg to record this. It is what happens when you hold the engine at a rev. You can see the STFTs going opposite of each other.
I have HP tuners now, how can I see if it was tuned for a 5.3MAF or LS1 MAF?
Also, is there a way I can see if it is tuned for LS1 injectors and not the 5.3 injectors?
I already downloaded a stock tune for a 1998 firebird and also a 2002 5.3 Silverado that I can compare stuff to. I'm just not sure how to find the calibration for MAF and injectors
I have HP tuners now, how can I see if it was tuned for a 5.3MAF or LS1 MAF?
Also, is there a way I can see if it is tuned for LS1 injectors and not the 5.3 injectors?
I already downloaded a stock tune for a 1998 firebird and also a 2002 5.3 Silverado that I can compare stuff to. I'm just not sure how to find the calibration for MAF and injectors
