flywheel

iTrader: (2)

I don't know what they were from, just had them sitting on shelf.... they were too wide to fit the 68-72 MMs, but they were about 3/8" taller then the actual 68-72 stands that I had to spend $60 on an don't need now.....I just cut them in half with my chop saw w/a wide blade then re-welded together, they fit perfect then....Was out test fitting the engine again tonite after cutting open the tranny tunnel to raise the tranny and looks like I might still need to a 1/4" to the pass side to get the tierod to clear the pan on a hard left turn.....fun, fun