trans wiring
Thread Starter
Teching In
Joined: Jan 2013
Posts: 39
Likes: 0
From: Detroit,MI
trans wiring Looking for wiring info I am doing a swap I have a 2005 6.0 4L80E and I have a three wires that are on fuse block connector that I don't know what to do with. Can any help
Thread Starter
Teching In
Joined: Jan 2013
Posts: 39
Likes: 0
From: Detroit,MI
Aright the wires are D3 light green [park neutral position park signal] not sure what to do with it sounds like it go's to cluster. F11 dark green [park/neutral start switch] not sure what to with this ether. I was assuming I could leave the neutral safety switch on the trans and use it? A11 [trailer back up lamp supply voltage] I think this would be for back up lamps?
Thanks,John
Thanks,John
Sounds like you pretty much got it figured out. If you want to use the NSS, you only need the dark green and a pink wire. You would run your start wire from the ignition switch to the pink wire in the 'E' terminal of the NSS connector, then the dark green wire in 'G' would go to the starter relay on terminal 85. 86 would go to ground, 30 would go to the battery and 87 would go to the starter solenoid.
