Custom adapter shafts?
Thread Starter
Launching!
Joined: Feb 2010
Posts: 276
Likes: 1
From: Mid Mo via Lancs. England
Custom adapter shafts? Anyone know of anyone that can make one of these, out of one piece then hardened? Basically it goes between the 4L60E and the Range Rover transfer case. And no, nobody makes a thing for this swap!
This one was made from a 4L60E slip yoke, with the end milled off, then the inside bored to an interference fit then TIG welded.
The end result after a little fight foot action with the new 6.0...
On a side note, the engine runs like a top, apparently as the old 5.3 never broke the damn shaft!
Martin
This one was made from a 4L60E slip yoke, with the end milled off, then the inside bored to an interference fit then TIG welded.
The end result after a little fight foot action with the new 6.0...
On a side note, the engine runs like a top, apparently as the old 5.3 never broke the damn shaft!
Martin
Thread Starter
Launching!
Joined: Feb 2010
Posts: 276
Likes: 1
From: Mid Mo via Lancs. England
Thanks Andrew.
I have actually installed their CV style axle shafts in someones Jeep. Not sure if they can do internal splines, but will call them tomorrow for sure!
Cheers
Martin
I have actually installed their CV style axle shafts in someones Jeep. Not sure if they can do internal splines, but will call them tomorrow for sure!
Cheers
Martin
