Wiring question
Thread Starter
Teching In
Joined: Aug 2013
Posts: 27
Likes: 0
Wiring question Hey guys. I'm working on the ls transformation in a fox mustang. I completely gutted the factory mustang wiring harness and replaced it with a Painless wiring kit. I am using the ls factory PCM and harness. I am merging the painless kit with the factory PCM and wire harness. The painless kit has a provision for the electric fuel pumps. The PCM also has a output signal for the fuel pump. Which one would you use to power the fuel pump and why. Thanks for the help.
Staging Lane
Joined: Mar 2015
Posts: 55
Likes: 0
I think I Would use the LS harness. I am doin the same with my car, minus the painless harness. Just using my factory wirin for everything body electrical related, and the LS harness for everything engine electrical related. I figure they call it stand alone because you can run the engine without needing it in a vehicle essentially. I figure if I use the LS for the fuel pump as well then it just makes sense. I'm going to try and use the LS pcm like it was meant to be used basically.
Did painless sell you a harness for just body wiring? Or what? Is it a conversion harness? If so, why use any Of the LS harness?
Did painless sell you a harness for just body wiring? Or what? Is it a conversion harness? If so, why use any Of the LS harness?
TECH Enthusiast
Joined: Sep 2014
Posts: 732
Likes: 1
From: alburnett, iowa
your going to be wiring in a relay. power will be coming out of fuse on fuse box go to relay for key on power. pcm will give signal to trip relay. there be a ground on relay and if remember a 12v battery power as well. Lt1 swap.com shows how to wire it up, but you want/need relay in system.
