Ls1 standalone wiring
Thread Starter
Teching In
Joined: Dec 2011
Posts: 3
Likes: 0
From: Tampa,Fl
Ls1 standalone wiring I have a 2000 Z28 LS1 with a T56 trans, its in my Nissan 240sx, i need help with my wiring. i want to buy a standalone wiring harness but i seen that its not that hard to do it myself. if anyone can help. thank u for ur time
Your harness is almost stand alone already. The F-body harness is very easy to modify. Check out lt1swap. I modified my 2002 f body harness with their information.
Last edited by RPM WS6; May 1, 2015 at 11:33 AM. Reason: Non-sponsor link removed.
I haven't done it myself yet, but I pretty much have it figured out. Just haven't had much luck buying a reasonably priced harness. At first it was intimidating as hell, most of the guides I read online seemed to lack the most basic info. The more I read tho, the more it became clear. You just have to piece all the guides together until you find everything you need.
Last edited by RPM WS6; May 1, 2015 at 11:35 AM. Reason: Non-sponsor links removed.
Restricted User
Joined: Mar 2014
Posts: 7,192
Likes: 109
From: Ohio
I labeled all of the wires and removed them from the ECU connector. Plugged in all of the ones I needed to their connectors on the engine, mounted the ECU where I wanted it, and then ran the wires back into the connector. From there its a few fuses and relays.
The hardest part is getting the harness loom and tape off and then getting it untangled lol.
The hardest part is getting the harness loom and tape off and then getting it untangled lol.
