Has anyone here heard of 2nd gen Camaro LS headers being used for a '68'72 A body? I've seen someplace where a vendor had the same part number for both. I've been looking at so many different ones right now I can't remember where it might have been.

 

Just use 4th gen camaro headers.

 

4th gen fit. gotta cut the drivers side collector to get it shooting straight back so the exhaust looks a little more symmetrical.

 

I tried using a set on my '70 Chevelle. It cleared the brake distribution on the drivers side, but just barely. I went with the Hooker cast manifolds. They fit great, but could be a cost issue if the goal is to source cheap manifolds. There are pics in my BT.

 

I've seen that. I was wondering about a cut and weld or flex connector? I would use one on both sides to make it look symmetrical.

 

I just cut the 3" collector, miter cut it till it was parallel with the passenger side and welded it back on.