Exhaust kits
04-19-2016, 01:49 PM
#1
On The Tree
Thread Starter
Exhaust kits Am researching the mandrel bend kits out there. Any experience (good or bad) with any one in particular?
Was assuming a butt weld set up, but don't see a lot of those available. I was just planning on 2 1/2" aluminized as I'll be fitting it up myself and would just take it together and let someone with some skill finish the welds.
Are you guys using v-band clamps?
I'll leave what mufflers everyone likes for later.....
Thanks!
Was assuming a butt weld set up, but don't see a lot of those available. I was just planning on 2 1/2" aluminized as I'll be fitting it up myself and would just take it together and let someone with some skill finish the welds.
Are you guys using v-band clamps?
I'll leave what mufflers everyone likes for later.....
Thanks!
04-19-2016, 05:11 PM
#4
On The Tree
Thread Starter
Sorry, it's a 1955 Olds 88......
Might be able fit an "H" pipe but it would be within an inch of the trans pan......
Actually was just figuring duals.
Might be able fit an "H" pipe but it would be within an inch of the trans pan......
Actually was just figuring duals.