LS Headers for Toyota pickup build
07-09-2018 | 02:08 PM
#1
Thread Starter
Teching In
Joined: Sep 2017
Posts: 12
Likes: 0
LS Headers for Toyota pickup build Greetings everyone,
My current project is a 1990 Toyota pickup standard cab RWD with a 5.3 LS engine and 4L60E transmission from a 2006 Chevy Silverado. I installed a set of Hooker Block hugger headers with 2 1/2 inch collectors. The headers work fine but I would like to install a header setup where the tubes sweep backwards behind the started and not in front like the block hugger headers do. I ordered a pair of Hooker cast iron exhaust manifolds but when I tried to install the passenger side, the exhaust flange was hitting the frame of the truck. I read in some other sites where a LS swap headers for a S-10 might fit my truck project. Has anyone on this site done a LS swap on a S-10? Can you provide me with photos of your headers mounted? If anyone has any suggestions on other headers sets or LS kits that might fit my project, I would appreciate that information too. Thanks.
My current project is a 1990 Toyota pickup standard cab RWD with a 5.3 LS engine and 4L60E transmission from a 2006 Chevy Silverado. I installed a set of Hooker Block hugger headers with 2 1/2 inch collectors. The headers work fine but I would like to install a header setup where the tubes sweep backwards behind the started and not in front like the block hugger headers do. I ordered a pair of Hooker cast iron exhaust manifolds but when I tried to install the passenger side, the exhaust flange was hitting the frame of the truck. I read in some other sites where a LS swap headers for a S-10 might fit my truck project. Has anyone on this site done a LS swap on a S-10? Can you provide me with photos of your headers mounted? If anyone has any suggestions on other headers sets or LS kits that might fit my project, I would appreciate that information too. Thanks.