dakota digital tach issue.
Simple question - is the tach output wire from the LS1 PCM connected to the HDX control box at the tach input? For my LS engine and HDX equipped 70 El Camino, I'm not using any BIM equipment. I use the tach output wire from the PCM to the tach input wire on the HDX control box. Try that and see what happens.
Does the tach needle swing all the way though its arc and back at power up for the DD dash?
I did have to run setup in the HDX control box to make the tach needle more responsive to throttle input. I don't remember for sure but I also think I set the tach for a 5 volt signal out of the PCM. And eight cylinders, of course.
Rick







