When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
My fuel rail crossover is hitting my alternator. I still have the old truck accessories set up. What's the easiest remedy to fix this problem or am I going to have to get all the LS car accessories?
How about a 90* fitting on the fuel rail and then a straight fitting on the fuel line, the 90* fitting on the fuel rail should exit at a tighter angle than the 90* fitting on the fuel line, do the same on both sides.
On one of my LS swaps I ran the fuel line up to the back of the engine and then used a "T" fitting to run lines to the back of the fuel rails. I drilled and tapped the front of the fuel rails for NPT pipe plugs. So no front cross over.
Pic of the front.
How about a 90* fitting on the fuel rail and then a straight fitting on the fuel line, the 90* fitting on the fuel rail should exit at a tighter angle than the 90* fitting on the fuel line, do the same on both sides.
Yeah looks like thats what Im going to have to do unfortunately. Those damn fittings are like $50 a piece! Plus I will need straight fittings to adapt to my steel braided teflon lines. $$$$$$$