Driveshafts? What are you using?
Driveshafts? What are you using? I assume most of you have custom driveshafts? In any case were any of you able to retain your original drive shaft, with no cutting, lengthening, shortening required?
I have an aluminum driveshaft out of an LS1 camaro, and I was seriously thinking about trying to make that work when I swap the 5.3 into my 68 Chevelle.
I have an aluminum driveshaft out of an LS1 camaro, and I was seriously thinking about trying to make that work when I swap the 5.3 into my 68 Chevelle.
On The Tree
Joined: Nov 2006
Posts: 102
Likes: 0
From: baltimore, md
if it's too long you're set, if it's too short, afraid it won't work...
if it's too long, chances are a competent drive shaft shop should be able to cut it and weld an aluminum yoke on there to mate to your differential.
if it's too long, chances are a competent drive shaft shop should be able to cut it and weld an aluminum yoke on there to mate to your differential.
