Need help finalizing wiring
Need help finalizing wiring I'm putting an LM4 in my 65 Vette. I have a harness from a silverado that I weaned the auto tranny wiring from and the rear O2 sensor wiring from. That was actually fun. I'm now at the point where I need to marry the engine harness to the ignition. I have the block connector with several pink wires and orange wires. I had thought about using a truck under hood power center to have the relays for the fuel pump and starter. I don't think I need that much though. Does anyone know the designation for that rectangular black connector and is there a legand of which terminal does what.
This site has been a HUGE help in getting me this far. Thanks to all those that did the research on the pinouts.
Bob
This site has been a HUGE help in getting me this far. Thanks to all those that did the research on the pinouts.
Bob
the harness is 2005 Silverado. It is set up for DBW and the throttle body is also DBW. I don't however have a TAC or pedal yet. I read further into the sticky and that is helping. I had kind of stalled at the pinouts in that thread because that was what I was working on and forgot to go back and read the rest.
Thanks.
Thanks.
Last edited by rubrhammer; Jan 3, 2008 at 08:59 PM.
