Flexplate
Thread Starter
Staging Lane
Joined: Apr 2005
Posts: 56
Likes: 0
From: Stockholm, Sweden
Flexplate Do I have the 4L80e or the 4L65e flexplate on the LQ4?
I'm asking because I tried to fit a th400 and it was very tight between the converter and the flexplate. There is a spacer between the crank and the flexplate.
I'm asking because I tried to fit a th400 and it was very tight between the converter and the flexplate. There is a spacer between the crank and the flexplate.
if your converter is in all the way, a 400 should fit ok, with the .400 spacer and flat flywheel, which it looks like you have-i just installed one in mine
i had to pull the starter motor to install the converter bolts
i had to pull the starter motor to install the converter bolts
Thread Starter
Staging Lane
Joined: Apr 2005
Posts: 56
Likes: 0
From: Stockholm, Sweden
I tried again today and now it fit perfect. I dont know what went wrong last time i tried.
It looks tight to install the converter bolts.
My th400 came with a thick aluminum flexplate cover, and that won't fit when the trans i mounted to the lq4. Is it common that the thick aluminum convers wont fit when you have a LS engine?
It looks tight to install the converter bolts.
My th400 came with a thick aluminum flexplate cover, and that won't fit when the trans i mounted to the lq4. Is it common that the thick aluminum convers wont fit when you have a LS engine?
