LS1TECH - Camaro and Firebird Forum Discussion
LS1-LS2-LS3-LS6-LS7 PERFORMANCE
Conversions & Swaps
block hugger measurements needed

Conversions & Swaps LSX Engines in Non-LSX Vehicles

Sponsored by:

block hugger measurements needed

Reply Subscribe

Search this Thread

Old

Oct 8, 2008 | 09:45 PM

#1

Thread Starter

TECH Resident

iTrader: (64)

Joined: Jul 2005

Posts: 908

Likes: 0

From: sneaking in your back door as you leave!/cartersville ga

Default

block hugger measurements needed

i have approx 24" betweem framerails. so its going to be real close. the engine does sit a little higher than the framerails. so i am hoping for some real close headers.....fingers crossed...........

i am needing from outside of flange to outside flange

thanks
greg

Old

Oct 8, 2008 | 10:03 PM

#2

Staging Lane

iTrader: (1)

Joined: Aug 2008

Posts: 56

Likes: 0

Default

huggers do jus as the name says hug. i have them on my 69 impala and they dont stick out far at all

Old

Oct 8, 2008 | 10:04 PM

#3

Staging Lane

iTrader: (1)

Joined: Aug 2008

Posts: 56

Likes: 0

Default

huggers do jus as the name says hug. i have them on my 69 impala and they dont stick out far at all. good luck

Old

Oct 9, 2008 | 05:59 AM

#4

Thread Starter

TECH Resident

iTrader: (64)

Joined: Jul 2005

Posts: 908

Likes: 0

From: sneaking in your back door as you leave!/cartersville ga

Default

im aware that they hug, but i was wanting some measurement to verify the width. or some pics from the front of an engine

thanks
greg

Reply Subscribe

block, hugger, measurments

First
Prev
1 / 1
Next
Last

All times are GMT -5. The time now is 07:09 AM.