anyone has had the stealth cam?
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2008
Posts: 592
Likes: 0
From: Alvin, TX/HOUSTON,TX
anyone has had the stealth cam? Was wondering anyone has had the stealth cam on there c5 z06. I have a 04 z06 take off motor with about say 11,000 miles on it and have a cam just slightly bigger then the stealth cam . Wondering if anyone had it on there z06 and what they think , mods r , K&N. CAI, kooks 1 7/8 headers and 3 in y pipe with flowmaster cat back( I know I will change it out lol)
219/227 on a 115LSA With the cutouts open, it chops a decent amount (since idle speed is so low), but otherwise it's very tame. Specs are 219/227 on 115LSA. Picked up 45rwhp. Decent gains for a cam that picked up hp and tq EVERYWHERE on the curve.
I had the stealth 2 cam on my z28 it sounded pretty good, but not lopey or anything like that. Never got a chance to get it tuned because my transmission broke and we deployed, then I sold it when I got back. It certainly felt like it got a lil bit faster of course I also installed a fast 90/90 at the same time
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2008
Posts: 592
Likes: 0
From: Alvin, TX/HOUSTON,TX
Well went to go get the car tuned on Thursday. Could not tune it in 3rd gear (3800 circle d stall and built A4) cause my driveshaft was vibrating preatty bad and mike at gforce didn't want something horrible to happen. Car made 365 from a 2nd gear pull. Car should make about 15-20 more hp on a 3rd gear pull and then 8-10 more with cutout open. When the car had just a ls1 in it car ran best of 11.70 @ 116 .now it has a take off 04 zo6 motor in it. I'm hopping to get my zr1s traded for some drag wheels and put the new driveshaft in it . I need to go back also and get tuned with the 150 shot , I'm looking for some 10s with the 150 shot. By the way car ran the 11.7 full weight with heavy as rims never had a drag set up on it. So what yah think?
